Skip to content
Real Online Ruler

How to Measure Your Wrist Size

Buying a bracelet or sizing a watch online starts with one number: your wrist circumference. A strip of paper and our free on-screen ruler get you there in minutes.

Wrist size is the circumference around your wrist, usually taken just below the wrist bone. It is the starting point for bracelet sizing and a sanity check for watch fit — and it takes less than five minutes to measure well.

Method 1: The paper-strip method

No soft tape? Paper works just as well, and it does not stretch the way cheap tapes can.

  • Cut a paper strip about 2 cm wide.
  • Wrap it just below the wrist bone, snug but not tight.
  • Mark where the end overlaps, then lay the strip flat.
  • Read end-to-mark with the on-screen millimeter ruler — calibrate first for a true reading.

Method 2: String or a soft measuring tape

Wrap a non-stretchy string snugly around the same spot, mark where it meets, lay it straight without pulling, and measure it against the calibrated mm ruler. Measure the wrist you will actually wear the piece on — the dominant wrist is often slightly larger.

The Real Online Ruler workspace with the millimeter unit selected
The on-screen millimeter ruler — ideal for reading a paper strip or string precisely.

From wrist size to bracelet size

Your wrist measurement is not the bracelet size — you add ease for the fit you want. As a rule of thumb, add 1 to 2 cm depending on fit:

FitAdd to wrist measurementFeels like
Snug+0.6 to 1 cmSits close, minimal sliding — good for tennis bracelets
Comfort+1.5 cmMoves a little — the most popular fit
Loose+2 to 2.5 cmDrapes and slides — good for chunky chains and cuffs

Bracelet styles matter too: bangles and slip-ons must also fit over your hand, so size up if your palm is wide relative to your wrist. When in doubt, check the jeweler’s own chart — ease conventions vary slightly by brand.

Watch fit: how snug is right?

A watch should sit snug: it stays put when you move your arm but is not tight. The classic test is one finger under the band — if a finger slides underneath comfortably, the fit is right; if it will not fit, the band is too tight. For metal bracelets, a jeweler removes links to dial this in; for leather or NATO straps, pick the hole that passes the finger test.

Tips for an accurate measurement

  • Measure just below the wrist bone, where a bracelet naturally sits.
  • Keep the strip snug but not tight — no indenting the skin.
  • Use a non-stretchy string; yarn and elastic lie about length.
  • Measure twice and average if the readings differ.
  • Keep browser zoom at 100% while reading the on-screen ruler.
The millimeter ruler on a phone screen
The mm ruler on a phone — useful for a quick check while shopping.

Try it on your screen right now

The live ruler is on the home page — calibrated to your display in under a minute.

Open the ruler